How To Configure And Reset D-Link Dwr-111 Router. If you have not changed the default settings, the (wan ports are normally yellow) step 3:
DLink Technical Support
Hold paper clip down for 10 seconds and release. (wan ports are normally yellow) step 3: 2 reset button press this button with an unfolded paperclip and hold for ten seconds to reset the device. This router is great for situations where an impromptu wireless network must be set up, or wherever conventional network access is unavailable. How to change ssid and password of the router? Ensure that you have connected successfully to the router. The unit will reboot automatically. Simply plug it in to create an instant hotspot. Enter the username (admin) and password (blank by default), and then click ok or log in. If you have not changed the default settings, the
With the unit on, place a paper clip into the hole on the back of the unit labeled reset. Open your web browser and type in the ip address of the router (192.168.0.1 by default). This router is great for situations where an impromptu wireless network must be set up, or wherever conventional network access is unavailable. The unit will reboot on its own. Connect the ethernet cable to the wan (or internet) port of both your modem and router, connecting the two. The default ssid and password are printed on the bottom of your router. Using the paperclip, press and hold the reset button for more than ten seconds. Click the tools tab at the top, then click the system tab on the left pane. Give it a moment to start up with a light indication. How to change ssid and password of the router? To perform a factory reset, please follow the steps below.
